by Mike Cleaver » Sun Jun 15, 2008 12:56 pm
I think I'll always curse the guy who invented Dymo tape.
As soon as that came out, every engineer decided to label the board with the stuff.
If it was a tube board, the glue on the Dymo tape turned into a substance only kryptonite or the equivalent would remove.
Usually, you had to carefully scrape off the plastic part without scratching the finish on the board and then use something like GoJo, the industrial hand cleaner used by auto mechanics, to dissolve the hardened muck.
It came off a little easier from the transistorized boards.
IIRC, the RCA boards installed in the "new" station were RCA BC7's.
They too became bastardized over the years, with engineers adding extra buttons, pots, etc.
I think my brother ended up with one of them but it was only good for salvage by then.
Mike Cleaver Broadcast Services
Engineering, News, Voice work and Consulting
Vancouver, BC, Canada
54 years experience at some of Canada's Premier Broadcasting Stations